1. Manuals
  2. Brands
  3. ENCAD Manuals
  4. Printer
  5. Croma 24
  6. Getting started

ENCAD Croma 24 Getting Started

Hide thumbs

Advertisement

Table of Contents

Getting Started

for Macintosh iMac and G4 computers
P/N 210247-00

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Croma 24 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for ENCAD Croma 24

Summary of Contents for ENCAD Croma 24

  • Page 1: Getting Started

    Getting Started for Macintosh iMac and G4 computers P/N 210247-00...
  • Page 2 Croma24 Getting Started for Macintosh 1. Introduction 1. Introduction 3. Installing roll guides 3. Installing roll guides Roll guides support roll media. If you plan to use only Setting up your Croma24 printer takes only a few minutes. sheet media, you will not need them. This guide explains how to: Note: if you are planning to install the optional printer •...

  • Page 3: Connecting Cables

    Croma24 Getting Started for Macintosh 4. Connecting Cables 4. Connecting Cables Turn off power to the computer. (Printer should be unplugged.) Plug the FastPort into the parallel port on the back of Croma24 Buttons and Indicators the printer. (Figure 3) Plug one end of the crossover (network) cable into the RJ45 jack on the back of the Macintosh.

  • Page 4: Loading Roll Media

    Croma24 Getting Started for Macintosh 5. Loading roll media 5. Loading roll media Handle your media carefully to avoid wrinkles or creases. Because the media can absorb skin oils, it's a good idea to wear light cotton gloves when han- dling the media to prevent unwanted fingerprints in the printed piece.

  • Page 5: Installing Printer Driver Software

    Croma24 Getting Started for Macintosh 6. Installing printer driver 6. Installing printer driver 7. Installing ink cartridges 7. Installing ink cartridges software software Your printer comes with four ink cartridges: yellow (Y), magenta (M), cyan (C), and black (K). The drivers included with your printer support iMac Note: Keep cartridges sealed until ready to use.

  • Page 6: Aligning Cartridges

    Croma24 Getting Started for Macintosh 8. Priming 8. Priming 9. Aligning cartridges 9. Aligning cartridges Cartridge alignment is necessary for best quality Next, you will want to prime the cartridges. Priming output. Align the cartridges each time you install a cartridges clears the inkjets and helps to make sure new cartridge.
  • Page 7 Croma24 Getting Started for Macintosh 10. Paper axis calibration 10. Paper axis calibration Black Color Executing the Paper Axis Calibration test will have the Color Vertical Head-to-Head Calibration printer draw a set of vertical marks to calibrate the paper axis. To measure the marks laid down by the printer, you will need a ruler or scale at least 33 inches (838.2 mm) long.

  • Page 8: Getting Help

    Copyright © ENCAD, Inc. 2000, All Rights Reserved. ENCAD ® and Croma24™ are trademarks of ENCAD, Inc. FastPort is a trademark of DIGI International. Macintosh, iMac, Mac and G4 are trademarks of Apple Computer.

Table of Contents