Reinstalling The Right Cover Assembly - ENCAD CADJET 2 Service Manual

Disassembly/Assembly
4.6

Reinstalling the Right Cover Assembly

1. Make sure that all wires are inside the Right Cover Assembly area
as you begin to put the Right Cover Assembly back on so that
none of the wires are pinched between the Right Cover Assembly
and the Right Side Plate.
2. Align the back of the Right Cover Assembly over the connector
clips on the parallel port. Remove the rubber band holding the
connector clips together.
3. Reinsert the bottom back screw on the inside of the Right Cover
Assembly.
screwdriver, tighten the bottom back screw and the top and front
screws.
overtighten.
4. Put the Top Cover back on.
5-22
See Figure Chapter 5 .5.
All three screws should be firmly tightened.
Using a #2 Phillips
Do not
CADJET 2