Table of Contents
Advertisement
General Information
SHEET MEDIA
SKEW
STEPPER
STOP BIT
TRANSDUCER
UART
UNI-DIRECTIONAL
VECTOR
VELOCITY
1-24
Media that is packaged in individual sheets and is loaded
and fed through the front of the plotter.
The rotation of the media from the initial inserted position
(not the rotational inaccuracy of the initial media loading).
Affects line length accuracy, especially in the paper axis.
May be measured, in the demo plot or any plot, by how far
the line on the left margin is different from the line on the
right margin.
Sometimes referred to as "SLEW."
Section 9.0 of this chapter for information about determining
the Skew and Chapter 6 for the adjustment procedures.
The media drive motor. The motor rotates one step for each
pulse generated by the drive circuit. Position is controlled by
the number of pulses generated.
In the RS-422/432 configuration, one or two bits following a
transmitted data byte which notify the receiver that the
information is complete.
Converts dynamic quantity into voltage.
Universal Asynchronous Receiver/Transmitter. An interface
device
used
between
communications devices.
Cartridges on the plotter fire ink on the media during right to
left movement only.
A graphic created by geometric lines. HP-GL and HP-GL/2
files are vector files.
The time-rate of linear motion in a given direction.
Commonly referred to as speed.
bit
serial
and
bit
CADJET 2
See
parallel
Advertisement
Table of Contents
