Reinstalling The Carriage Assembly - ENCAD CADJET 2 Service Manual

8.3

Reinstalling the Carriage Assembly

Note:
NOTE
1.
CAUTION
2.
1. Make sure the left end of the Trailing Cable extends out beyond
the left end of the Stabilizer Bracket.
2. Slide the Carriage Assembly onto the left end of the Slide Shaft,
making sure that the Encoder Strip fits into the slot in the Slider
and the Encoder on the Carriage PCB. Use your right index finger
to guide the belt as you slide the Carriage Assembly from left to
right on the Slide Shaft.
3. Move the Carriage Assembly to the left end of the Slide Shaft and
align the left bushing on the Carriage Assembly with the left end of
the Slide Shaft.
CADJET 2
Make sure you clean the Slide Shaft before installing the
Carriage Assembly. You may use Isopropyl Alcohol to clean
it. Be sure it is dry before installing the Carriage Assembly.
Never use Isopropyl Alcohol to clean the brass bushings on
the Carriage Assembly. Use only a dry cloth.
When you slide the Carriage Assembly onto the Slide Shaft,
make sure that the Encoder Strip fits into the slot in the
Slider and the Encoder which are on the Carriage PCB.
Disassembly/Assembly
5-37