Table of Contents
Advertisement
15. With your left hand, push the back of the Frame Tensioner
towards the right end of the Y-Bracket and, with your right hand,
slip the Carriage Belt over the Servo Motor pulley on the right end
of the unit. Make sure that the guides in the Carriage Belt are
properly fitted over the Servo Pulley.
16. Gently move the Carriage Assembly from end to end and make
sure that the Carriage Belt is not rubbing against any other parts.
17. Use a #1 Phillips screwdriver to reattach the plastic left Cam
Actuator back onto the front of the Y-Arm. Before careful not to
overtighten the screw or the plastic may break. Make sure the
orientation is correct (see Figure Chapter 5 .18).
18. Reattach the Trailing Cable Cover to the back of the Y-Arm.
19. Proceed to Section 8.4.
CADJET 2
Disassembly/Assembly
5-41
Advertisement
Table of Contents
