Table of Contents
Advertisement
Maintenance
To prevent damage to the plotter, do not slide the Carriage on the
shaft until the alcohol is completely dry.
CAUTION
6. Manually move the Carriage from end to end.
7. Wipe the Slide Shaft with a dry cloth to remove any deposits left
by the Carriage.
8. Reconnect the power cord and interface cables and run the
PRIME plot.
concerning the appearance of the PRIME plot.) During plotting,
make sure that:
a.
b.
If the Carriage Assembly does not move freely, or if there is
Carriage vibration and/or any noise, clean the Slide Shaft again
and repeat the PRIME plot. If the problem is not resolved, refer to
Chapter 4, Section 11.17 "Plotter Carriage Moves Erratically" for
additional troubleshooting steps.
3-4
(See Chapter 4, Section 11.8 for information
the Carriage Assembly slides freely on the Slide Shaft, and
there is no Carriage vibration or any noise.
CADJET 2
Advertisement
Table of Contents
