Table of Contents
Advertisement
8.3
Other Functional Requirements
The paper skew has a tendency to increase as the size of paper
increases (B-Size through E-Size). When adjusting the skew, make
sure that:
1. the skew for B-Size paper is as close to the low end of the range
as possible; and
2. a minimum gap still remains between all Upper Roller Supports
and the Y-Arm. The test for acceptable gap is that a piece of bond
paper can be inserted through the gap without interference; that is,
the gap must be at least the thickness of a piece of bond paper.
See Figure Chapter 6 .8.
Supports so that they touch the Y-Arm's cut outs.
Figure Chapter 6 .8: Test for Minimum Acceptable Gap
CADJET 2
Avoid adjusting the Upper Roller
Calibration
6-33
Advertisement
Table of Contents
