Stabilizer Bracket And Encoder Strip - ENCAD CADJET 2 Service Manual

Disassembly/Assembly

10.0 Stabilizer Bracket and Encoder Strip

Note: 1. If the Encoder Strip is not damaged, do not remove it. It
NOTE
The Encoder Strip is attached to the Stabilizer Bracket with double-
sided 3M tape. The Stabilizer Bracket is held on the Y-Arm by means
of three screws which go into the back of the Y-Arm. The Encoder
Strip should be inspected for visual damage to windows, noting any
cracks, scratches, or bends in the mylar.
5-52
cannot be reused.
2. If the Encoder Strip is damaged, the entire Stabilizer Bracket
must be replaced. Follow the directions under Sections 10.1
and 10.2 in this chapter.
Support and Service department to obtain an RMA number
(see Chapter 1, Section 3.0). Be sure to specify whether you
have a D-Size or E-Size model. A new Stabilizer Bracket will
be sent to you which will already have the new Encoder Strip
installed on it, as well as the tapes for the Trailing Cable.
The person taking your call will explain the procedure for the
exchange.
Figure Chapter 5 .23: Encoder Strip
Contact ENCAD's Technical
CADJET 2