Table of Contents
Advertisement
4.3
Service Calibration
SERVICE
CALIBRATION→
CALIBRATION
DEADBAND=XX
CALIBRATION
VERT LINES(ONE)
CALIBRATION
VERT LINES(ALL)
CALIBRATION
SLOW DEADBAND
CADJET 2
This
level
contains
performing the electrical calibration of the plotter.
See Chapter 6, Sections 9.0 through 14.0 of this
manual for the procedures for performing the
electrical calibration.
This option prints the deadband test and allows the
value to be changed.
This option prints two 1-1/2" vertical lines within each
of the 16 regions in uni-directional mode.
This option prints two 1-1/2" vertical lines within each
of the 16 regions in bi-directional mode.
This option prints 1 line of deadband across all 16
regions.
Troubleshooting
firmware
instructions
for
4-17
Advertisement
Table of Contents
