Remove The Keypad, Display, And Display Power Converter - ENCAD NovaJet Pro 600e Service Manual

NovaJet PRO 600e Service Manual
8. Using a #2 Phillips screwdriver, secure the Right Cover with two
screws located on the left side (torque to 15 in-lbs) and three located
under the baseplate (torque to 8 in-lbs.)
To install the Top Cover:
9. Insert the pin located on the right side of the Top Cover into the
corresponding hole on the Right Cover Assembly.
10. While depressing the retracting stop assembly on the left side of the
Top Cover, lower the left side of the Top Cover into position and
secure it to the Left Cover Assembly by releasing the retracting stop
assembly.
Remove the Keypad, Display, and Display Power
Converter
1. Perform steps 1 through 9 of the Remove the Left, Top, and Right
Covers procedure to remove the Top and Right Covers.
5-6 Assembly\Disassembly
Applying too much torque to the lower screws can cause
the mounts for the standoffs on the cover to break, requir-
ing a replacement of the cover.