Remove The Keypad, Display, And Display Power Converter - ENCAD 60e Service Manual

Novajet PROe Series Service Manual
8. Using a #2 Phillips screwdriver, secure the Right Cover with
two screws located on the left side (torque to 15 in-lbs) and
three located under the baseplate (torque to 8 in-lbs.)
To install the Top Cover:
9. Insert the pin located on the right side of the Top Cover into
the corresponding hole on the Right Cover Assembly.
10. While depressing the retracting stop assembly on the left side
of the Top Cover, lower the left side of the Top Cover into
position and secure it to the Left Cover Assembly by releasing
the retracting stop assembly.
Remove the Keypad, Display, and Display Power
Converter
1. Perform steps 1 through 9 of the Remove the Left, Top, and
Right Covers procedure to remove the Top and Right Covers.
100 Assembly\Disassembly
Applying too much torque to the lower screws can
cause the mounts for the standoffs on the cover to
break, requiring a replacement of the cover.