Configure A Multicast Route - Digi IX10 User Manual

Services
3. Under Services, click NTP.
The NTP server status page is displayed.

Command line
Show NTP information
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show ntp
> show ntp
NTP Status Status
-----------------
Status
Sync Status : Up
Remote
Offset
----------------
- ------
*ec2-52-2-40-158
+1.561
128.136.167.120
1.895
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a multicast route

Multicast routing allows a device to transmit data to a single multicast address, which is then
distributed to a group of devices that are configured to be members of that group.
To configure a multicast route:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
IX10 User Guide
command at the system prompt:
: Up
Refid
Jitter
-------------
129.6.15.32
0.991
128.227.205.3
0.382
Configure a multicast route
ST T When Poll Reach
-- - ---- ---- -----
2 u 191 1024 377
3 u 153 1024 1
Delay
------ -----
33.570
43.583 -
579