Table of Contents
Advertisement
Services
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a multicast route
Multicast routing allows a device to transmit data to a single multicast address, which is then
distributed to a group of devices that are configured to be members of that group.
To configure a multicast route:
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Multicast.
4. For Add Multicast route, type a name for the route and click .
5. The new route is enabled by default. To disable, uncheck Enable.
6. Type the Source address for the route. This must be a multicast IP address between 224.0.0.1
and 239.255.255.255.
7. Type the Source port. Ensure the port is not used by another protocol.
8. Select a Source interface where multicast packets will arrive.
9. To add one or more destination interface that the IX20 device will send mutlicast packets to:
a. Click to expand Destination interfaces.
b. Click .
c. For Destination interface, select the interface.
d. Repeat for additional destination interfaces.
IX20 User Guide
Configure a multicast route
503
Advertisement
Table of Contents
