Figure 3.5 [Internet(Mail Only) Connection Environment Settings] Window; Table 3.1 Input Items For The [Internet(Mail Only) Connection Environment Settings] Window - Fujitsu PRIMEQUEST 1000 Series Installation Manual

PRIMEQUEST 1000 Series REMCS Installation Manual
CHAPTER 3 REMCS Service Start Procedure

FIGURE 3.5 [Internet(Mail Only) connection environment settings] window

1. Enter the values for the following items.

TABLE 3.1 Input items for the [Internet(Mail Only) connection environment settings] window

Item
SMTP Server
Sender E-mail Address
Authentication type
AUTH SMTP type
UserID
Password
POP Server
Division method
Division Size
Enter the SMTP server name or IP address in single-byte alphanumeric
characters and symbols.
Enter the sender e-mail address in single-byte alphanumeric characters
and symbols.
Select the authentication type from [No certification], [POP Before
STMP], and [AUTH STMP].
Valid if you specified the authentication type [AUTH SMTP].You can
select from [AUTO (initial value)],
[CRAM-MD5], [PLAIN], and [LOGIN].
Enter the user ID for the authentication server in single-byte alphanumeric
characters and symbols.
Enter the password for the authentication server in single-byte
alphanumeric characters and symbols.
If you specified the authentication type [POP Before STMP], enter the
POP server name or
IP address in single-byte alphanumeric characters and symbols.
Select the division method from [No division], [Mail division], and [Event
division].
The initial value at new installation is [Event division]. The initial value
at the firmware update time is the setting before the firmware update.
Enter the partitioning size in the range of 10 to 100 Kbytes. The initial
value is 64 Kbytes.
17
Description
C122-E120-06EN