Figure 11.6 [Asr (Automatic Server Restart) Control] Window; Table 11.7 [Asr Control] Window Display / Setting Items - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 11 Chapter System Startup/Shutdown and Power Control
11.4 Automatic Partition Restart Conditions
2. Set the automatic restart conditions.
The setting items of the [ASR Control] window are listed in the table below.
Items
ASR
Number of Restart Tries
Action after exceeding
Restart tries
Retry Counter
Boot Watchdog
Boot Watchdog
Timeout time (seconds)
Action when watchdog
expires

FIGURE 11.6 [ASR (Automatic Server Restart) Control] window

TABLE 11.7 [ASR Control] window display / setting items

Description
Set the number of retries for restarting the operating system when there is time
out by Boot Watchdog, or Software Watchdog of SVAS, or the hardware error
occurs and OS shuts down.
The number of times can be set up to 0-10 times. When 0 is specified, it does not
retry.
Default is five times.
Repeat the restart by Watchdog Timeout and sets the action when the above-
mentioned retry number is exceeded. The actions are as below.
- Stop rebooting and Power Off: Reboot process is stopped, power supply of
partition is cut off.
- Stop rebooting: Reboot process is stopped, and the partition is stopped.
- Diagnostic Interrupt assert: Reboot process is stopped, instructs the NMI
interruption for partition. Tries to collect the data for investigation (damp) for
the investigating the cause of stoppage, of the partition which has stopped.
Default setting is 'Stop rebooting and Power Off'
Displays the number of actual possible retries.
Enable/disable of the Boot Watchdog function of ServerView is set.
The start of OS is observed when setting it to Enable. After OS starts, Boot
Watchdog is stopped by ServerView.
Default is Disable.
Time until Boot Watchdog does timeout is set.
The range of 1-6000 can be set.
Default is 6000 seconds (=100 minutes).
Action when Boot Watchdog does timeout is set.
In Action, there is the following.
351
CA92344-0537-08