Client Authentication Host - ADTRAN 1000R Series Command Reference Manual

Command Reference Guide

client authentication host

Use the client authentication host command to enable the unit to act as an Xauth host when this IKE
policy is negotiated with a peer.
Variations of this command include the following:
client authentication host username <username>
client authentication host username <username> password <word>
client authentication host username <username> password <word> passphrase <phrase>
Syntax Description
username <username> Specifies the value sent via Xauth as the username.
password <word>
passphrase <phrase> Optional. Specifies the value sent via Xauth as the passphrase. This is only used with
Default Values
By default, if this command is not present in the IKE policy the unit does not act as an Xauth host.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Functional Notes
The specified credentials are programmed into the unit and there is no prompt for entering values
real-time. Therefore, schemes requiring real-time input or additional responses (e.g., SecureID) are not
supported. The client authentication host command and the client authentication server commands
are mutually exclusive. Refer to
information.
Usage Examples
The following example specifies the login credentials to be sent:
(config-ike)#client authentication host username jsmith password password1 passphrase phrase
61200510L1-35E
Specifies the value sent via Xauth as the password.
authentication type OTP (one time password).
Command was introduced.
client authentication server list <listname>
Copyright © 2005 ADTRAN
IKE Policy Command Set
on page 1264 for more
1262