Replacing The Stopper Cylinder - JUKI FX-1 Maintenance Manual

FX-1/FX-1R Maintenance Manual

5-10. Replacing the Stopper Cylinder

(1) Loosen the nut
(2) Remove the mounting nut
(3) Turn the cylinder shaft
(4) When installing a new stopper cylinder, reassemble the components in the order of steps (3) to
(1).
Make sure that the cylinder
smoothly.
Apply Loctite 277 to the air cylinder screw. Assemble the components so that the distance from
the nut end face of the cylinder
figure below.
A=16.4 ± 0.1 mm
(5) Adjust the opening of the speed controller.
To adjust the speed controller, tighten the screw fully, and then open it only one rotation from
the fully closed position.
(6) After the components have been reassembled, supply air (0.49 MPa) to check that the stopper
cylinder moves smoothly.
Speed controller
Table 5-10-1
Part name
AIR CYLINDER
STOPPER TIP
at the top end of the rod.
.
to detach the cylinder
is aligned along the slot on the stopper frame and moves
to the end face of the stopper clevis
Figure 5-10-1
Part No.
PA1002009A0
L164E221000
from the stopper clevis
Apply Loctite 277.
5-14
.
is as shown in the
Rev. 2.00