Rep 11.89-171 Main Tray And Paper Length Sensors; Rep 11.90-171 Bottom Tray And Paper Sensors - Xerox WorkCentre 5790 Series Service Manual

REP 11.89-171 Main Tray and Paper Length Sensors

Parts List on PL 11.175
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the main tray or relevant sensor,
1
Pull the lug on one side of
the tray to disconnect from
the frame pivot.
Figure 1 Main tray assembly removal
Replacement
Reverse the removal procedures to replace the inserter main tray and paper length sensors.
Xerox® WorkCentre® 5790 Family
WARNING
GP 14. Disconnect the power cord
WARNING
Figure 1
3
Remove the relevant
paper length sensor.
2
Remove 2
screws, then the
cover plate.

REP 11.90-171 Bottom Tray and Paper Sensors

Parts List on PL 11.175
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Undock the inserter, REP 11.82-171. Release the front and rear pivot tabs then lift the bot-
tom tray. Control the movement of the bottom tray springs.
May 2013
4-393
WARNING
GP 14. Disconnect the power cord
WARNING
Repairs/Adjustments
REP 11.89-171, REP 11.90-171