Adj 7.4 Tray 5 Module Tray Alignment - Xerox WorkCentre 5790 Series Service Manual

Machines W/TAG P-001. The adjustment must be performed in the following order:
1. Figure 2, turn the hand wheel in the centre of the tray 5 module to raise the casters off the
floor.
1
Turn the hand wheel to obtain
alignment.
2
Raise front and rear casters off of the floor.
Figure 2 Tray 5 alignment W/TAG P-001
2. Check the registration, refer to dC604
Repairs/Adjustments
ADJ 7.3, ADJ 7.4
Registration Setup Procedure.

ADJ 7.4 Tray 5 Module Tray Alignment

Parts List on PL 7.64
Purpose
To align the tray 5 module paper tray with the paper trays in the IOT module. Use this adjust-
ment when the top edge registration cannot be achieved using the NVM values in
istration Setup Procedure.
NOTE: Perform ADJ 7.3, Tray 5 Module to Machine Alignment, before starting this adjustment
procedure. Use both ADJ 7.3 and this adjustment to achieve correct hole punch alignment.
Before performing this adjustment return the NVM values for tray 5 to the nominal values.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
Make a sample print and determine which way and how far the tray needs to be moved. After
the adjustment is made, take a sample print.
1. Loosen the two screws on the docking pin bracket,
Figure 1 Docking pin bracket
May 2013
4-448
WARNING
14. Disconnect the power cord. Electricity can cause
Figure 1.
1
Loosen two screws.
Xerox® WorkCentre® 5790 Family
dC604 Reg-