Xerox WorkCentre 5790 Series Service Manual page 1223

13. Set the crease blade in the correct position,
2
Push the rear of the
crease blade forward to
contact the setup tool
3
Tighten 2 screws
14. Fully retract the crease blade by positioning the crease blade knob (6d),
4, with the arrow in the up position.
15. Tighten the six remaining crease blade clamp screws, refer to
16. Remove both crease blade setup tools and return them to the storage position.
17. Install all of the removed components and check the operation of the BM module.
Xerox® WorkCentre® 5790 Family
Figure 4.
Figure 4 Blade positioning
PL 11.161 Item
Figure 3.
4
Tighten 2 screws
May 2013
4-485
1
Push the front of the
crease blade forward to
contact the setup tool
Crease blade
Setup tool
Repairs/Adjustments
ADJ 11.4-171