Xerox WorkCentre 5790 Series Service Manual page 1401

Software requirements:
• gawain.uImage - Linux kernal file.
• gawain_ramdisk.uboot - Linux root file system file.
• The DLM file to be loaded.
Perform the following:
NOTE: For additional information or if the Forced Altboot fails, refer to the help file supplied
with the PWS Altboot tool.
1. Print a configuration report.
2. If possible, perform a NVM save, refer to
3. Switch off the machine, GP 14.
4. Disable the wireless network on the PWS.
5. Set the proxy server setting on the PWS. Perform the following:
a. Open Start / Control Panel / Network Connections/Local Area Connections.
b. Open Local Area Connection.
c. In the General tab, highlight the Internet Protocol (TCP / IP) icon.
d. Click on the Properties button.
e. Select Use the following IP address.
NOTE: Before changing the proxy server settings, record the original IP address and
Subnet mask. The original settings are reset at the end of this procedure.
f. Set the IP address of the PWS to 192.168.0.2.
g. Set the Subnet mask of the PWS to 255.255.255.0.
NOTE: A default gateway setting is not required.
h. Click on OK to close the properties dialog box.
i. Click on Close to close the Local Area Connection Properties dialog box.
j. If any settings have been changed, reboot the PWS.
6. Disconnect the ethernet cable from the machine.
7. Connect the crossover ethernet cable from the PWS network port to the machine network
port.
8. Connect the null modem serial cable from the PWS serial port to the machine serial port.
9. Start the PWS AltBoot tool.
Xerox® WorkCentre® 5790 Family
GP 5.
10. Browse to and highlight the folder that contains the upgrade files,
11. Switch on the machine, GP
age and uboot files will begin.
12. After file transfer, the settings menu is displayed in the terminal window,
May 2013
6-17
Figure
Figure 14 Browse for folder
14. After approximately 10 seconds, the transfer of the uIm-
Figure 15 Settings menu
General Procedures/Information
14. Select OK.
Figure 15.
GP 4