Rep 11.2-110 Input Drive Belt And Paper Entry Transport Motor - Xerox WorkCentre 5790 Series Service Manual

REP 11.2-110 Input Drive Belt and Paper Entry Transport
Motor
Parts List on PL 11.14.
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the 2K LCSS rear cover, REP
2. Remove the motor and drive belt, Figure
2
Disconnect the
motor harness.
Figure 1 Removing the drive belt
Repairs/Adjustments
REP 11.2-110
WARNING
GP 14. Disconnect the power cord
WARNING
11.1-110.
1.
1
Remove the
spring.
Replacement
1. Place the belt around the pulleys.
2. Install the motor screws, but do not tighten.
3. Install the spring
4. Rotate the shaft by hand to ensure the belt runs smoothly over the pulleys and allow the
spring to tension the belt,
5. Tighten the motor screws and re-connect the harness.
6. Install the 2K LCSS rear cover,
4
Remove the
drive belt.
3
Remove 2
screws and
motor
May 2013
4-234
ADJ 11.4-110.
REP 11.1-110.
Xerox® WorkCentre® 5790 Family