Rep 8.18 Tray 1 And Tray 2 Transport Roll Drives Motor - Xerox WorkCentre 5790 Series Service Manual

Figure 5 Cover location
3. After completing the replacement procedure, perform the
Repairs/Adjustments
REP 8.17, REP 8.18
1
Door aperture.
2
The lug on the cover must
locate in the door aperture.
dC604 Registration Setup.
May 2013

REP 8.18 Tray 1 and Tray 2 Transport Roll Drives Motor

Parts List on PL 8.25
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the rear cover, PL 8.10 Item
2. Remove the waste toner bottle and door,
3. Remove tray 1 and tray 2.
4. Prepare to remove the transport roll drives motor,
3
Remove screw
4-134
WARNING
GP 14. Disconnect the power cord from the
WARNING
1.
REP 9.1.
Figure 1.
2
Remove 2 screws
Figure 1 Preparation
Xerox® WorkCentre® 5790 Family
1
Remove the
belt by sliding
it off the idler
pulley