Xerox WorkCentre 5790 Series Service Manual page 1122

2. Remove the relevant limit switch, Figure
1
Remove 1 screw, then the
upper limit switch.
2
Remove 1 screw, then the
lower limit switch.
Figure 1 Bin 1 limit switches
Replacement
Reverse the removal procedures to replace the Bin 1 upper and lower limit switches.
Repairs/Adjustments
REP 11.75-171, REP 11.76-171
1.
REP 11.76-171 Bin 1 Upper Level Sensor
Parts List on PL 11.140
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the HVF front and rear covers,
2. Disconnect the connector, then remove the transmitter or receiver as necessary,
Transmitter
Figure 1 Bin 1 upper level sensor removal
Replacement
Reverse the removal procedures to replace the transmitter or receiver of the bin 1 upper level
sensor.
May 2013
4-384
WARNING
GP 14. Disconnect the power cord
WARNING
REP 11.1-171.
Receiver
Xerox® WorkCentre® 5790 Family
Figure 1.