Xerox WorkCentre 5790 Series Service Manual page 903

Replacement
NOTE: New paper feeder assemblies come ready configured for use in tray 3. When a new
tray 4 paper feeder is required, follow the steps below.
1. If a new tray 4 paper feed assembly is being installed, perform steps 2 to 9. If the old tray
4 paper feed assembly is being re-installed, perform steps 5 to 9.
2. Remove the support bracket, Figure
Figure 2 Support bracket removal
3. Remove the tray 3 paper guide, REP
Xerox® WorkCentre® 5790 Family
2.
2
Slide the support
bracket rearwards
and remove
1
Remove the screw
8.55.
4. Install the tray 4 paper guide,
5. Install the paper feed assembly,
Figure 3 Feed assembly installation
6. Push tray 4 in slowly and check that the tray does not foul the paper feed assembly.
7. Connect the four PJs, refer to
8. The remainder of the replacement is the reverse of the removal procedure. Refer to
before refitting the screws.
9. If a new paper feed assembly has been installed, reset the tray 4 feeds count to zero in
the HFSI feature screen. Refer to
May 2013
4-165
REP 8.56.
Figure 3.
1
Locate both
tongues into the
frame slots
Figure 1.
GP 17 High Frequency service Items.
Repairs/Adjustments
2
Install 2
screws
GP 6
REP 8.41