Xerox WorkCentre 5790 Series Service Manual page 932

Take care when removing the latch. The latch contains a compressed spring, which can
cause injury when released.
5. Remove the screw from the latch, Figure
Figure 3 Remove the latch
Replacement
1. Replacement is the reverse of the removal procedure.
2. Apply plastislip grease, PL 26.10 Item
(i.e. the hole the pin fits into) prior to insertion.
3. Refer to Figure 4. Check the following:
a. The latch pin is correctly lined up with the flats on the latch plate.
b. The latch handle and the latch pin are correctly lined up.
c. When reinstalling the developer paddle into the pivot plate, check that the spring is
correctly located on the tie bar and on the feature on the developer paddle,
Repairs/Adjustments
REP 9.6
WARNING
3.
1
Remove the screw
2
Remove the latch
8, to the internal diameter of the bush on the frame
Figure 2.
May 2013
4-194
Latch pin
Latch plate
Latch handle
Latch pin
Figure 4 Latch alignment
Xerox® WorkCentre® 5790 Family