Xerox WorkCentre 5790 Series Service Manual page 1115

6. Centralise the coupler alignment tool with the drive unit coupler,
1
Adjust the position of the drive unit.
Figure 5 Centralise the drive coupler
Xerox® WorkCentre® 5790 Family
Figure 5.
Alignment tool
Drive coupler
2
Ensure the drive coupler is centralised
with the alignment tool.
May 2013
7. Secure the drive unit in the centralised position,
Figure 6 Secure the drive unit
8. Attach the alignment tool onto the drive assembly for future use.
9. Carefully slide back the BM and engage the drive unit coupler.
10. Check that the harnesses do not obstruct the BM crease roll motor encoder disc.
11. Reverse the removal procedures to replace the tri-folder
4-377
Figure 6.
2
Slide out the
BM and remove
the coupler
alignment tool.
1
Secure the drive unit,
tighten 4 screws.
Repairs/Adjustments
REP 11.68-171