Xerox WorkCentre 5790 Series Service Manual page 1221

9. Position the crease blade setup tools on the crease roll shafts,
Figure 1 Setup tool positioning
Xerox® WorkCentre® 5790 Family
Figure 1.
One tool is shown located on
the front of the crease rolls.
Locate the second tool on the
rear of the crease rolls in the
same manner.
Crease blade setup tool
Crease roll shafts
10. Lock the crease gate in the open position,
Figure 2 Lock the crease gate
May 2013
4-483
Figure 2.
2
Insert an interlock cheater in
the teeth as shown to prevent
the gate from falling.
1
Lift the gate to the highest
position.
Repairs/Adjustments
ADJ 11.4-171