Xerox WorkCentre 5790 Series Service Manual page 852

Replacement
Replacement is the reverse of the removal procedure. Refer to
screws.
1. Refer to the kit instructions and install the spacers on the paper feed assembly.
2. Slide the spacer to the end of the shaft,
Figure 2 Location of the spacer
Repairs/Adjustments
REP 8.2
GP 6 before refitting the
Figure 2.
Position of the spacer.
3. Make sure that the feed assembly locates in the stack limiter bracket,
Figure 3 Locate the paper feeder assembly
4. Install the paper feed assembly and push the tray in slowly.
NOTE: Check that the tray does not touch the feed assembly.
5. Connect the ribbon cable and the PJs,
6. If a new feed roll assembly is installed, reset the tray 3 feed count to zero in the HFSI fea-
ture screen. Refer to GP 17
May 2013
4-114
Locate the feeder into the stack
limit bracket
Figure 1.
High Frequency service Items.
Xerox® WorkCentre® 5790 Family
Figure 3.