Xerox WorkCentre 5790 Series Service Manual page 1192

6. Check that the tool is correctly located, as shown in
NOTE: In Figure 4, the spring loaded access cover is shown in ghosted form for clarity.
Figure 4 Correct tool location
Repairs/Adjustments
ADJ 7.6
Figure 4.
Nudger roll shaft.
Tab in the location slot.
Retard Shield Check and Adjustment
1. Check the position of the retard shield,
Setting
Retard
tool
Paper
shield.
flange.
strip.
Figure 5 Retard shield check
2. If the paper strip does not feed between the flange of the PFP setting tool and the retard
shield then retard shield is positioned correctly, proceed to
and Adjustment.
If the paper strip does feed between the flange of the PFP setting tool and the retard
shield then the retard shield requires adjustment, continue at step 3.
May 2013
4-454
Figure 5.
1
Attempt to feed a strip of standard xerox
80gsm (20lb) paper between the lower
side of the PFP setting tool flange and
the retard shield.
Stack Height Sensor Check
Xerox® WorkCentre® 5790 Family