Rep 7.4 Tray 3 And Tray 4 Elevator Cables (W/O Tag 151) - Xerox WorkCentre 5790 Series Service Manual

5. Remove the tray 3 or tray 4 elevator motor,
Tray 3 elevator motor.
Figure 1 Elevator motor removal
Replacement
The replacement is the reverse of the removal procedure.
Repairs/Adjustments
REP 7.3, REP 7.4
Figure 1.
HCF control PWB.
Tray 4 elevator
motor.
2
Remove the
elevator
motor.
1
Remove the
screw.
Low paper
sensor.

REP 7.4 Tray 3 and Tray 4 Elevator Cables (W/O TAG 151)

Parts List on PL 7.15
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
NOTE: The elevator drives at the front and at the rear are similar for both trays.
1. Remove tray 3 (W/O TAG 151) or tray 4 (W/O
2. Release the cables from the appropriate front drive pulley,
Figure 1 Front elevator cables release
May 2013
4-80
WARNING
GP 14. Disconnect the power cord from the
WARNING
TAG 151), REP 7.2.
Figure 1.
2
Remove the short cable
from the drive pulley.
3
Remove the long cable
from the drive pulley.
1
Remove the E-clip.
Xerox® WorkCentre® 5790 Family