Adj 7.2 Tray 5 Paper Tray Guide Setting - Xerox WorkCentre 5790 Series Service Manual

Figure 3 Set the paper tray guide to 8.5 x 11 size
4. To lock the paper tray guide in position, push the retaining clips in the reverse direction to
that shown in Figure 1.
Repairs/Adjustments
ADJ 7.1, ADJ 7.2

ADJ 7.2 Tray 5 Paper Tray Guide Setting

Parts List on
Retaining clips.
Purpose
To adjust the paper tray guides in tray 5 for A4 / A3 or 8.5 x 11 / 11 x 17 inch paper.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
1. Open tray 5 door and allow the tray to lower and remove the paper stack.
2. Adjust the paper guide to the required paper size,
• To set the paper tray guide to A4 / A3 paper size, move the paper guide to the outer
position.
• To set the paper tray guide to 8.5 x 11 / 11 x 17 inch paper size, move the paper
guide to the inner position.
3. Check the registration, refer to
May 2013
4-446
PL 7.64
WARNING
GP 14. Disconnect the power cord. Electricity can cause
Figure
dC604 Registration Setup Procedure.
Figure 1 Paper guide adjustment
1.
Paper size indicator window
1
Move the handle up to
release the lock on the
paper guide.
2
Use the handle to move the
paper guide to the required
paper size.
3
Move the handle down to
lock the paper guide.
Xerox® WorkCentre® 5790 Family