Xerox WorkCentre 5790 Series Service Manual page 783

Take care when removing PJ1 on the IOT PWB, the pins can be easily damaged.
12. Disconnect PJs on the power and control assembly,
Disconnect HT
lead C and G.
Disconnect PJ35
and PJ64.
Figure 3 Power and control assembly
13. Remove the main frame ground wire, refer to the
14. Remove the waste toner full sensor,
Xerox® WorkCentre® 5790 Family
CAUTION
Figure 3.
Disconnect
PJ2.
Disconnect
PJ25.
Disconnect
PJ18.
Disconnect PJ1.
01A Ground Distribution RAP.
REP 9.4.
15. Unclip the wiring harness from the retaining clip and move the harness away from the
drives module, Figure 4.
16. Disconnect PJ57 on the waste toner door switch,
Figure 4 Harness and door switch
May 2013
4-45
Figure 4.
2
Disconnect PJ57.
1
Remove harness
from the retaining
clip.
Repairs/Adjustments
REP 4.5