Rep 7.22 Tray 3 And Tray 4 Removal (W/Tag 151) - Xerox WorkCentre 5790 Series Service Manual

4. Keep the tray assembly against the base of the tray 5 module, then reinstall the elevator
motor shaft.
5. Raise the tray to ensure that it is in horizontal alignment with the lower feeder assembly,
Figure 6. If necessary remove the elevator motor shaft then repeat the replacement pro-
cedure from step 3.
Tray assembly
Figure 6 Tray alignment
Repairs/Adjustments
REP 7.21, REP 7.22
Lower feed assembly

REP 7.22 Tray 3 and Tray 4 Removal (W/TAG 151)

Parts List on PL 7.18.
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the paper from the two trays.
2. Remove the right hand cover,
3. Remove the tray 3 and tray 4 front covers,
2
Remove 2 screws then
remove the tray 4 front cover.
Figure 1 Tray front covers removal
NOTE: If only tray 3 is to be removed then do not remove the left hand stop.
NOTE: If tray 4 needs to be removed then remove tray 3 first.
May 2013
4-102
WARNING
GP 14. Disconnect the power cord from the
WARNING
PL 7.25 Item 7.
Figure 1.
1
Remove 4 screws, then
remove the tray 3 front cover.
Xerox® WorkCentre® 5790 Family