Xerox WorkCentre 5790 Series Service Manual page 1019

8. Figure 3. At the HVF rear, turn the back stop latch as indicated, to release the back stop.
The back stop will move in the outboard direction.
Turn the latch
REAR VIEW
Figure 3 Releasing the back stop
Xerox® WorkCentre® 5790 Family
9. Remove the stapler assembly,
Backstop
Replacement
NOTE: The ejector unit returns to the home position when the HVF is initialized.
1. Slide the stapler assembly into the tray, taking care not to trap the earth wire at the rear.
2. At the HVF rear, pull the back stop to the rear and hold it there while turning the back stop
latch clockwise. Release the back stop, which should slide forward until stopped by the
latch.
3. Reconnect all PJs and re-install the screws.
May 2013
4-281
Figure 4.
Figure 4 Removing the stapler assembly
1
Remove the screw
2
Slide the stapler
assembly forward
Repairs/Adjustments
REP 11.2-171