Rep 11.1.1 Tray 2; Rep 11.1.2 Single Tray Module (Separation From Iot) - Xerox WorkCentre 5020 Service Documentation

REP 11.1.1 Tray 2

Parts List on PL 11.1
Removal
To avoid personal injury or electrical shock, ensure that the machine is completely off
before disassembling or adjusting. Turn OFF the power and unplug the machine.
1. Remove all paper from Tray 2.
2. Pull out Tray 2.
3. Lift the front side of Tray 2 and remove the tray (Figure 1).
Replacement
• To install, do the removal steps in reverse order.
Initial Issue
WorkCentre 5020
WARNING
Figure 1

REP 11.1.2 Single Tray Module (Separation from IOT)

Parts List on PL 11.1
Removal
To avoid personal injury or electrical shock, ensure that the machine is completely off
before disassembling or adjusting. Turn OFF the power and unplug the machine.
The IOT is heavy. Do this procedure with 2 persons.
1. Disconnect the connector. (Figure 1).
1 Disconnect the connector.
2 Pull out the cable clamp.
July, 2007
4-83
WARNING
WARNING
Figure 1
Repairs and Adjustments
REP 11.1.1, REP 11.1.2