Replacement
1.
Replacement is the reverse of the removal procedure. Refer to
screws.
2.
Locate the support bracket on the machine frame and tightened the screws,
Figure 4 Support bracket position
Repairs/Adjustments
REP 8.15
3.
Ensure that the mylar guide is located correctly,
GP 6
before refitting
Figure
4.
1
Locate the tab
on the bracket
in the hole in
the frame.
2
Tighten two
screws.
1
Position the mylar guide above
the machine frame.
4.
After completing the replacement procedure, perform the
May 2013
4-130
Figure
5.
Figure 5 Mylar guide position
dC604
Registration Setup.
Xerox® WorkCentre® 5790 Family