c.
Figure
7, Ensure that the tabs of the outer gear keyed clutch plate are not outside of
the grooves in the gear.
Figure 7 Outer gear keyed clutch plate
d.
Figure
8, ensure that the final shaft keyed clutch plate does not come off of the shaft
during installation.
Figure 8 Outer gear keyed clutch plate
e.
Tighten the screw on the front end of the shaft until it reaches a hard stop.
Repairs/Adjustments
REP 11.52-171
3.
Outer gear keyed
clutch plate
Tabs
Grooves
Final shaft keyed
clutch plate
May 2013
4-350
f.
Check that the lower crease roll gear and clutch assembly is secure on the shaft. If
necessary, repeat steps A to D.
Install the remainder of the removed components by reversing the removal procedure.
Xerox® WorkCentre® 5790 Family