Rep 10.6 Nip Roll Guide - Xerox WorkCentre 5790 Series Service Manual

REP 10.6 Nip Roll Guide

Parts List on PL 10.11
Purpose
This procedure is used to repair the following:
• Single exit nip roll, PL 10.11 Item 7.
• Double exit nip roll, PL 10.11 Item 8.
• Nip roll guide, PL 10.11 Item 10.
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the output device and the right hand cover,
2. Remove the rear cover, PL 8.10 Item
3. Remove the tie bar, Figure 1.
1
Remove 4 screws
2
Disconnect harness from
inverter motor driver PWB
Figure 1 Remove tie bar
Xerox® WorkCentre® 5790 Family
WARNING
GP 14. Disconnect the power cord
WARNING
PL 8.10 Item 9.
1.
3
Remove tie bar
4. Remove the nip roll guide, Figure
2
Disconnect the harness
from the exit sensor and
from the nip roll guide
5. Remove the following components from the nip roll guide as required:
• IOT exit sensor.
• Single exit nip roll.
• Double exit nip roll.
Replacement
1. Replacement is the reverse of the removal procedure. Refer to
screws.
May 2013
4-209
2.
1
Remove two screws
3
Remove the
nip roll guide
Figure 2 Nip roll guide
GP 6
Repairs/Adjustments
before refitting the
REP 10.6