Rep 8.33 Tray 5 Transport Drive Belt - Xerox WorkCentre 5790 Series Service Manual

REP 8.33 Tray 5 Transport Drive Belt

Parts List on PL 8.40
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the rear cover, PL 7.60 Item
2. Prepare to remove the drive belt, Figure
4
Remove two screws.
5
Release the motor assembly from the drive belt.
Figure 1 Preparation
Repairs/Adjustments
REP 8.33
WARNING
GP 14. Disconnect the power cord from the
WARNING
9.
1.
1
Remove two screws.
2
Remove the E-clip.
3
Loosen the screw,
move the belt ten-
sioner fully
upward, tighten
the screw.
3. Remove the transport drive belt,
Replacement
1. Replacement is the reverse of the removal procedure. Refer to
screws.
2. Allow the tension idler to tension the belt and then tighten the screw,
May 2013
4-156
Figure 2.
Figure 2 Drive belt removal
GP 6
Xerox® WorkCentre® 5790 Family
1
Remove the
drive belt.
before refitting the
Figure 1.