Rep 7.13 Tray 5 Empty Sensor - Xerox WorkCentre 5790 Series Service Manual

REP 7.13 Tray 5 Empty Sensor

Parts List on PL 8.45
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the top cover, PL 7.60 Item
2. Prepare to remove the tray 5 empty sensor,
1 2
Disconnect the harness. Remove eight screws marked A.
Figure 1 Preparation
Xerox® WorkCentre® 5790 Family
WARNING
GP 14. Disconnect the power cord from the
WARNING
10.
Figure 1.
3
Lift the upper
plate.
3. Remove tray 5 empty sensor,
1
Disconnect the harness.
Figure 2 Tray 5 empty sensor removal
Replacement
1. The replacement is the reverse of the removal procedure. Refer to
the screws.
2. Make sure that the spring on the paper feed assembly is in the correct position,
Figure 3 Feed assembly spring
May 2013
4-91
Figure 2.
2
Press the tabs to release the sensor.
GP 6
1
Place the spring under the
post.
Repairs/Adjustments
before refitting
Figure 3.
REP 7.13