Xerox WorkCentre 5790 Series Service Manual page 1095

7. Figure 2, remove the front spring.
Figure 2 Front spring removal
8. Remove the top cover, then the rear cover,
9. Fully push in the BM.
10. Remove 4 screws securing the BM PWB mounting plate to the frame, allow the PWB and
mounting plate to hang down, giving access to the rear nip spring and linkage.
Xerox® WorkCentre® 5790 Family
1
Move the spring to the corner cutout
2
Flex the spring
slightly and slide out
of the hole
REP 11.1-171.
11. Figure 3, remove the rear lower linkage.
Figure 3 Rear linkage removal
May 2013
4-357
4
Release the linkage
from the spring hook
3
Slide the linkage from
the shafts
2
Remove the E-clip
1
Remove the KL-clip
Repairs/Adjustments
REP 11.58-171