Xerox WorkCentre 5790 Series Service Manual page 1053

4. Figure 1, remove the relevant staple head.
3
Using a 5.5mm socket
and short extension fully
loosen the screw until the
staple head is released.
Leave the socket and
extension in position on
the screw
Figure 1 Staple head removal
Xerox® WorkCentre® 5790 Family
2
Loosen 1 screw
using a 5.5mm
socket and
ratchet driver
4
1
Disconnect the
Remove 2 screws
stapler harness
using a 5.5mm
and remove the
socket and
stapler
ratchet driver
May 2013
Replacement
1. Reverse the removal procedure to replace the BM staple heads.
2. Perform ADJ 11.3-171 Stapler Anvil Alignment.
4-315
Repairs/Adjustments
REP 11.27-171