Xerox WorkCentre 5790 Series Service Manual page 991

3
Remove the cover
2
Remove 2 screws
Figure 1 Entry guide cover removal
Xerox® WorkCentre® 5790 Family
Replacement
Refer to GP 6 before refitting the screws.
1. Bias the entry guide cover away from the paper guide when you tighten the screws.
2. The clearance between the entry guide cover and the paper guide must be a minimum of
1mm. Refer to
NOTE: If the clearance is less than 1mm, then install a new entry guide cover.
3. Run copies through the output device, if possible use heavy weight paper or labels.
Check for marks on the print and for damage to the paper. If there are no marks or dam-
age then install the covers.
1
Remove 2 screws
May 2013
4-253
Figure 2.
Figure 2 Entry guide cover clearance
Check for a minimum
clearance of 1mm
between the entry
guide cover and the
paper guide
Repairs/Adjustments
REP 11.15-110