Rep 8.36 Tray 5 Feed Motor; Rep 8.37 Tray 5 Transport Motor - Xerox WorkCentre 5790 Series Service Manual

REP 8.36 Tray 5 Feed Motor

Parts List on PL 8.40
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the rear cover, PL 7.60 Item
2. Remove tray 5 feed motor, Figure 1.
3
Remove the motor.
Figure 1 Feed motor removal
Replacement
1. The replacement is the reverse of the removal procedure. Refer to
the screws.
Xerox® WorkCentre® 5790 Family
WARNING
GP 14. Disconnect the power cord from the
WARNING
9.
1
Remove
two screws.
2
Disconnect
the harness.
GP 6 before refitting

REP 8.37 Tray 5 Transport motor

Parts List on PL 8.40
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the rear cover, PL 7.60 Item
2. Remove the drives plate, Figure
5
Disconnect both
motor harnesses.
Figure 1 Drives plate removal
May 2013
4-159
WARNING
GP 14. Disconnect the power cord from the
WARNING
9.
1.
3
Loosen the
screw, move the
belt tensioner
fully upward,
tighten the screw.
4
Remove 2 screws.
Repairs/Adjustments
REP 8.36, REP 8.37
1
Remove two
screws.
2
Remove the
E-clip.