Replacement
Reverse the removal procedure to replace the ROS.
Ensure that the harnesses are not damaged when the ROS is installed.
1.
If installing a new ROS, ensure that the ROS is the correct one for the machine speed.
Check that the part number is correct,
speed are labelled on the underside of the ROS, as shown in
2.
Figure
4. Ensure that the harness is routed correctly.
Figure 4 ROS harness routing
3.
Go to
dC604
Registration Setup, check/adjust the registration.
4.
Perform
ADJ 9.2
Image Quality Adjustment Routine.
Repairs/Adjustments
REP 6.1
CAUTION
PL 6.10 Item
4. The part number and the machine
Figure
4.
Label (Underneath).
Harness routing.
May 2013
4-76
Xerox® WorkCentre® 5790 Family