Xerox WorkCentre 5790 Series Service Manual page 1191

4. Install the PFP setting tool, Figure 2.
Nudger roll shaft.
1
Locate the PFP setting tool onto the feed roll
shaft, so that the nudger roll shaft rests on
top of the setting tool flange.
Figure 2 Setting tool location
Xerox® WorkCentre® 5790 Family
5. Engage the tab in the setting tool location slot,
Upper feed
assembly tab.
May 2013
4-453
Figure 3.
1
Ensure that the location
slot of the PFP setting
tool slides onto and fully
locates on the tab of the
upper feed assembly.
Figure 3 Tab location
Repairs/Adjustments
ADJ 7.6