Rep 2.4 User Interface Touch Screen - Xerox WorkCentre 5790 Series Service Manual

REP 2.4 User Interface Touch Screen

Parts List on PL 2.10
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Figure 1 ESD Symbol
Ensure that E.S.D. procedures are observed during the removal and installation of the user
interface touch screen.
1. Remove the user interface assembly,
2. Put the user interface assembly on a flat surface.
3. Remove the user interface screen clamp assembly, refer to
Repairs/Adjustments
REP 2.4
WARNING
GP 14. Disconnect the power cord from the
CAUTION
REP 2.1
REP 2.2.
4. Remove the user interface touch screen,
Figure 2 UI control PWB removal
Replacement
1. The replacement is the reverse of the removal procedure. Refer to
screws are installed.
2. When replacing the ribbon cables, the blue flash should face away from the UI control
PWB.
May 2013
4-26
Figure 2.
1
Raise the end of the touch screen,
then remove the touch screen in
the direction of the arrow.
GP 6 before the
Xerox® WorkCentre® 5790 Family