Rep 14.15 Scan Motor (W/Tag 150); Rep 14.16 Scan Motor And Scan Carriage Drive Belts (W/Tag 150) - Xerox WorkCentre 5790 Series Service Manual

REP 14.15 Scan Motor (W/TAG 150)

Parts List on PL 14.15
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
1. Remove the CVT and document glass,
2. Figure 1. Remove the scan motor.
2
1
Remove 3 screws.
Scribe a line round the
motor bracket.
Figure 1 Scan motor
Replacement
1. The replacement procedure is the reverse of the removal procedure.
2. Ensure the motor bracket is aligned with the scribe line on the base of the scanner,
1.
Repairs/Adjustments
REP 14.15, REP 14.16
WARNING
GP 14. Disconnect the power cord
REP 14.6.
4
Disconnect the motor
harness and then
remove the motor.
3
Remove the scan motor
drive belt.
REP 14.16 Scan Motor and Scan Carriage Drive Belts (W/
TAG 150)
Parts List on PL 14.15
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the CVT glass, document glass and CVT ramp,
2. Remove five screws securing the PWB cover,
3. Lift the PWB cover and disconnect PJ923 on the scanner PWB,
4. Remove the scan motor,
5. Prepare to remove the belts,
2
Remove 2 screws
Figure
May 2013
4-422
WARNING
GP 14. Disconnect the power cord
WARNING
REP 14.6.
PL 14.15 Item 1.
PL 14.15 Item
REP 14.15.
Figure 1.
1
Scribe around the intermediate
pulley bracket
Figure 1 Preparation
Xerox® WorkCentre® 5790 Family
4.