Rep 10.20 Inverter Sensor - Xerox WorkCentre 5790 Series Service Manual

REP 10.20 Inverter Sensor

Parts List on PL 10.12
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the inverter assembly, REP
2. Remove the inverter sensor, Figure
1
Follow the sequence
to remove the sensor
2
Disconnect the har-
ness from the sensor
Tab to secure the
harness
Figure 1 Remove the inverter sensor
Replacement
1. The replacement is the reverse of the removal procedure. Refer to
the screws.
2. Route the harness under the tab on the upper baffle,
3. Make sure that the upper baffle and the inverter assembly duct are linked correctly. When
the latch 3d/4d is released, the two items lift together.
Repairs/Adjustments
REP 10.20
WARNING
GP 14. Disconnect the power cord
WARNING
10.2.
1.
GP 6 before refitting
Figure 1.
May 2013
4-232 Xerox® WorkCentre® 5790 Family